Compaq 400 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400C 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400CX 486 DX2/40 MHZ 250 MB 4 MB 8.4, 410 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 350 MB 4 MB 9.5, 410CX 486 DX2/50 MHZ 350 MB 4 MB 8.4, 420C 486 DX4/75 MHZ 350 MB 4 MB 10.4, 420C 486 DX4/75 MHZ 420 MB 8 MB 10.4, 420CX 486 DX4/75 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 720 MB 8 MB 10.4, 430CX 486 DX4/100 MHZ 720 MB 8 MB 10.4 Chapter 3.5 Hard Drive

4.To install the tilt foot, reverse the previous steps. Discard the old screws and replace with new screws.

This section contains removal procedures for the following hard drive components:

o Hard drive compartment cover

o Hard drive

o Hard drive bracket

Removing the Hard Drive Compartment Cover

To remove the hard drive compartment cover, follow these steps:

1.Disconnect all power from the computer and remove the battery pack, diskette, and PC Card, if installed (Section 3.2).