Compaq 400 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400C 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400CX 486 DX2/40 MHZ 250 MB 4 MB 8.4, 410 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 350 MB 4 MB 9.5, 410CX 486 DX2/50 MHZ 350 MB 4 MB 8.4, 420C 486 DX4/75 MHZ 350 MB 4 MB 10.4, 420C 486 DX4/75 MHZ 420 MB 8 MB 10.4, 420CX 486 DX4/75 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 720 MB 8 MB 10.4, 430CX 486 DX4/100 MHZ 720 MB 8 MB 10.4 151

7.Connect the display cable and the backlight cable to the inverter board (Section 3.21).

8.Replace the inverter board (Section 3.21).

9.Replace the bezel (Section 3.21).

10.Connect the display ground cable [1] to the LIF clip above the serial port connector (Figure 3-99).

11.Carefully insert the end of the display ground cable into the ZIF connector slide on the system board (Figure 3-99).

IMPORTANT: Ensure that the ZIF connector slide is in its fully upward position and that it remains so while you are inserting the cable into it. Before closing the slide, ensure that the cable is fully seated (to the white insertion line) in the ZIF connector.