Compaq 400 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400C 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400CX 486 DX2/40 MHZ 250 MB 4 MB 8.4, 410 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 350 MB 4 MB 9.5, 410CX 486 DX2/50 MHZ 350 MB 4 MB 8.4, 420C 486 DX4/75 MHZ 350 MB 4 MB 10.4, 420C 486 DX4/75 MHZ 420 MB 8 MB 10.4, 420CX 486 DX4/75 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 720 MB 8 MB 10.4, 430CX 486 DX4/100 MHZ 720 MB 8 MB 10.4 Chapter 3.4 Tilt Feet

6.To install the handle bracket, reverse the previous steps. Discard the old screws and replace with new screws.

This procedure is necessary if replacing the tilt feet or if separating the display assembly from the system unit module.

Removing the Tilt Feet

To remove the tilt feet, follow these steps:

1.Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2).

2.Using a Torx T8 , remove the tilt foot screw (Figure 3-7). Screws from the tilt feet are not reusable and must be discarded.

3. Remove the tilt foot (Figure 3-7).