Compaq 745A manual Troubleshooting, Shipping Your Monitor

TROUBLESHOOTING

You may save time and money by solving common monitor problems using the following simple, easy-to-apply solutions. If you are unable to solve the problem using these troubleshooting solutions, visit the Compaq website at www.compaq.com/athome or contact your Compaq authorized dealer, reseller, or service provider.

Problem	Possible Cause	Solution
Screen is blank	Power cord disconnected	Connect the power cord
	Power switch off	Turn on power
	Signal cable improperly	Connect signal cable properly
	connected
	Screen blanking utility is active	Press any key on the keyboard or move the
		mouse
Image appears blurred or	Monitor is not properly	Press the left or right Function Select Control
indistinct.	adjusted.	button to access the On-Screen Display
		(OSD), then select Auto Adjustment			to
		correct*
Image appears too dark	Brightness and contrast are	Press the left or right Function Select Control
	too low	button to access the On-Screen Display
		(OSD), then select the brightness		and/or
		contrast	icon to adjust to desired levels*
Image is too large, too small, or	Monitor is not properly	Press the left or right Function Select Control
not properly centered	adjusted.	button to access the On-Screen Display
		(OSD), then select Auto Adjustment			to
		correct*
Your monitor is not recognized	You have not installed the	Use the enclosed FP745A Monitor Installation
by the operating system	proper driver.	Diskette and instructions, or contact your
		Compaq authorized dealer, reseller, or service
		provider
Monitor is overheating	There is not enough ventilation	Leave at least 3 inches (76mm) of ventilation
	space to allow proper airflow	space surrounding your monitor, and do not
		place objects on top of your monitor

* Refer to the "Using Your On-Screen Display" section for detailed instructions.

Shipping Your Monitor

If you need to ship your monitor, keep the original packing box.

11