Removal and Replacement Procedures

4.Remove the TM2.5 × 5.0 screw 1 that secures the display inverter cable ground loop to the heat spreader (Figure 5-25).

5.Disconnect the display inverter cable 2 from the system board.

6.Remove the TM2.5 × 5.0 screw 3 that secures the display video cable ground loop to the heat spreader.

7.Disconnect the display video cable 4 from the system board.

8.Remove the display video cable from the routing channels in the heat spreader and the top cover 5.

Figure 5-25. Removing the Display Screws and

Disconnecting the Display Cables

5–32

Maintenance and Service Guide