Removal and Replacement Procedures

8.Lift the front edge of the palm rest and swing it up and back 1 until it rests on the top cover (Figure 5-30).

9.Release the ZIF connector to which the diskette drive cable is attached 2 and disconnect the diskette drive cable 3 from the system board.

10.Release the ZIF connector to which the system board- to-TouchButton board cable is attached 4 and disconnect the cable 5 from the TouchButton board.

Figure 5-30. Removing the Palm Rest

11.Remove the palm rest from the base enclosure. Reverse the preceding procedures to install the palm rest.

5–38

Maintenance and Service Guide