Removal and Replacement Procedures

3.Remove the three TM2.5 × 5.0 screws 1 that secure the charger board to the base enclosure (Figure 5-36).

4.Lift the front edge of the charger board shield 2 until it clears the base enclosure, then slide the shield forward to remove it.

5.Lift up on the back edge of the charger board 3 to disconnect it from the system board.

6.Remove the charger board from the base enclosure.

Figure 5-36. Removing the Charger Board

Reverse the preceding procedures to install the charger board.

Maintenance and Service Guide

5–45