Compaq manual C160/C180/C200/C240/C360 Memory Module Location

Changing Your Workstation’s Hardware Configuration

Installing Additional Memory

Perform the following steps to add memory modules to your workstation.

1Remove the main tray assembly according to the directions in “Removing the Main Tray Assembly” earlier in this appendix.

2Use Figure 40 to locate the memory modules on the CPU Assembly.

0A

4A

0B

4B

2A

5A

2B

5B

3A

1A

3B

1B

Rear of Main Tray

Figure 40 C160/C180/C200/C240/C360 Memory Module Location

This workstation has 12 memory slots, labeled 0A, 0B through 5A, 5B. The memory configuration is 32 MB to 1.5 GB installed in pairs of 16 MB, 32 MB, 64 MB, or 128 MB memory modules.

Memory modules must be installed in pairs of equal capacity.

Always install the largest capacity memory modules in the lowest numbered memory slots.

For example, if you have a pair of 16 MB memory modules and a pair of 64 MB memory modules, first install the pair of 64 MB memory modules in slots 0A and 0B, then install the 16 MB modules in slots 1A and 1B.

NOTICE:Memory slots must be filled in order from 0A and 0B through 5A and 5B.

127