Using the Projector
2.Remove the lens cap 1 from the projector by pressing in on the tabs on either side of the lens cap and pulling it straight out.
3.Press the Power/Standby button 2 on the top of the projector and allow the projector to warm up for one to two minutes.
When the projector has warmed up, the Compaq startup screen displays and the LED on the Power/Standby button 2 turns green.
4.Power on your source (computer, Pocket PC, VCR, etc.) and launch the software application being used to display images on the projection screen. If applicable, press the Function key on the computer designated for external display.
If there is a long delay between the time the startup screen displays and the time the software application is launched, the lamp may shut off and the projector will automatically go into standby mode. If this happens, press the Power/Standby button 2 to power on the lamp.
When the startup screen disappears, the video from the attached computer displays. If there is no incoming video, the “No Source Found. Please Check Signal Cable” message will display on the projection screen.
Compaq iPAQ Microportable Projector MP1200 User’s Guide |
