Compaq MP1200 manual Before restarting the projector again

Troubleshooting

Troubleshooting (Continued)

Problem	Solutions
Lamp shuts off.	1. If the Standby LED flashes green,
	the projector has overheated and
	will automatically shut down. Wait
	five to ten minutes until the LED
	stops flashing and the
	Power/Standby button turns amber
	before restarting the projector again.
	2. A minor power surge may cause the
	lamp to shut off. Wait a few minutes,
	then turn it back on.
	3. When the lamp has reached the end
	of its life, the system will
	automatically turn off to prevent
	possible lamp rupture. Replace the
	lamp as described in the “Replacing
	the Projector Lamp Module” section
	of Chapter 7.
Lamp burns out or makes a	When the lamp reaches its end of life, it
popping sound.	will burn out and may make a loud
	popping sound. If this happens, the
	projector will not turn back on until the
	lamp module has been replaced.
	Contact your local Compaq authorized
	dealer, seller, or reseller to purchase a
	replacement lamp module. To replace
	the lamp, follow the procedures in the
	“Replacing the Projector Lamp Module”
	section of Chapter 7.

8–6 Compaq iPAQ Microportable Projector MP1200 User’s Guide