DIGITAL-LOGIC AG

SMX945 Condensed Manual V1.0A

3.2.Connect Peripherals to the Board

Prepare the following peripherals:

￿VGA Monitor (LCD or CRT) with a resolution up to 1024x768pixel

￿PS2 Keyboard

￿USB Mouse

￿LAN-Cable, if available

￿Hard disk or CompactFlash

￿USB CD-Drive or Floppy drive

￿Power supply with 12Volt and min. 30Watts

1.Connect the VGA-Monitor to the 15pin high density DSub-connector.

2.Connect the Keyboard to the PS/2 connector.

3.Connect the USB-Mouse to one of the USB-connectors.

4.Connect the hard disk with a 44pin cable to the IDE-connector.

Alternatively to the hard disk, the CompactFlash-Card may be inserted into the CF-socket.

The polarity must be correct. Pin1 of the cable must go to Pin1 of the connector, which has a red mark next to it (not visible in the photo). Otherwise the hard disk and/or the computer may be destroyed.

5.Connect a USB CD-Drive or a USB Floppy drive to one of the USB connectors.

6.Connect the 12Volt power supply to the power input of the computer board.

The polarity must be correct. Otherwise the electronic board may be destroyed.

7. Insert a boot device: USB-Stick, Floppy or bootable CF.

3.3.The Development Kit, Part Nr. 805390

The Development Kit (DK) is currently unavailable but would allow for an immediate start-up with the embedded system. The hard disk includes a DOS and a LINUX kernel V2.6 boot partition.

The material which will be included in the SMX945PC-DK (Development Kit) is not yet decided.

Item

Part Nr.

17

Page 17
Image 17
Compaq SMX945 user manual Connect Peripherals to the Board, Development Kit, Part Nr