Compex Systems SX-V, SONOSAX SX-S user manual Seite 16 von, Procedure, Optional

SONOSAX SX/S USER MANUAL Seite 16 von 22

{SX981134 Conical head screw M3x8 (4x)

{SX642403 24 kOhms 1% R0805 Resistor (2x)

{SXS351220 22pF 1% C0805 (1x)

{SXS644990 49,9 Ohms 1% R0805 Resistor (1x)

{SXS641503 15 kOhms 1% R0805 Resistor (1x)

{SX860131 Bantam mini-jack pre-wired (1x)

{SX140002 NPN-Transistor BC 550 C

When installing an SX022270 SX-S Extension Module in an SX-S mixing console with serial-number 16585 or lower R-64 and R-65 on the extension module operator board need to be replaced by 24kOhms 1% SMD R0805.

7.2 Procedure

On the Master Board (solder side) solder the 6 conductors of the ribbon cable(see PCB Layout)

Change Q1 (BC337) on the Masterboard with BC 550C (SX140002).

Mount the 12-pin Hirose socket in place of the last Input's 3-pin Neutrik.

Install the 6-pin Neutrik socket next to the 12-pin Hirose socket.

Install the Extension module beside the master board and connect the wires asindicated on the PCB Layout. Do not forget to install the additional 26-pin connector on the SX-S10 ribbon cable.

SX-S 10: Disconnect the Aux. XLR 3-pin male and replace it with SX860141,socket 1/4'' with 150mm shielded cable and Dubox case.

SX-S 6 SX-S 8: Remove the existing 1/4'' Jack, unsolder the connections on the Masterboard and reconnect to the Bantam Jack with cable provided. Install the SX860141, socket 1/4'' with 150mm shielded cable and Dubox case.

Click here for Illustration of INTERNAL connections, ajustments and switches

Click here for Master Module PCB Layout

NOTE:The ribbon cable connects to the PCB (from Left to right) Yellow - Brown - Orange - Green - Red - Blue.

Connections of the 6 pole Flatcable

Brown Cable	1	PFL-BUS-left
Red Cable	2	MASTER-BUS-right
Orange Cable	3	PFL-BUS-right
Yellow Cable	4	Auxiliary BUS
Green Cable	5	PFL Control-CDE (sense)

Connected to pin No 1 OP-7 Connected to pin No 1 OP-3 Connected to pin No 7 OP-7 Connected to cursor Aux potentiometer

Connected to point R-6/R-5/collector of Q1

Blue Cable 6 MASTER-BUS-left Connected to pin No 7 OP-3

7.3 Optional

External Slate MIC for the Mixer's operator

file://D:\Z_Library\Webcopy\sonosax\SXS\sxsume.html 26.08.2004