SONOSAX SX/S USER MANUAL | Seite 3 von 22 |
1.5 Closing the battery compartment
Replace the plastic side cover.
NOTE : Certain
Replace the battery compartment while holding in the
The battery compartment is in place when the
1.6 External power supply (also refer to 2.2 and 2.3)
SONOSAX
The DC power supply input connector (LEMO, Type FGJ IB 303CLLD62, SONOSAX Part nb. 860202) is located on the rear panel of the SONOSAX mixer. Pin No.3 is allocated to the NiCd batteries charge current. Nominal current is 400mA and nominal charging time is 15 hours.
WARNING : DO NOT ATTEMPT TO CHARGE
1.7Power supply block diagram
1.8Fuses
Your SONOSAX
{ON THE EXTERNAL DC PC BOARD. Located below the two faders of the master module. To gain access to this fuse, remove the bottom of the
RETURN TO TABLE OF CONTENTS
2. OPERATING INSTRUCTIONS
2.1 Switching on the SONOSAX mixer
Using
Depress POWER
{Check that batteries have been inserted correctly inside the battery compartment.
file://D:\Z_Library\Webcopy\sonosax\SXS\sxsume.html | 26.08.2004 |