4.2.2
CO, Cl2 and NO2 Generator (see Picture 2)
The CO, Cl2 and NO2 generator cells contain an internal fan. When replacing, please proceed as follows:
1Loosen the 4 screws on the backside of the instrument and seperate the two halves. (Use caution as the LED’s are attached to the top case)
2Remove the battery.
3Unsolder the 3 wires from the old generator cell.
4Unscrew the 4 screws securing the PCB and remove the PCB.
5Unscrew the 3 screws of the generator cell , which secure it to the bottom case, and remove the old generator cell. Insert the new generator cell and tighten the 3 screws.
6Reinsert the PCB and tighten the screws. Please make sure that the switch pin has not moved and that it easily activates the switch on the PCB.
7Reconnect the battery.
8If required, readjust the generator current to the following specifications:
-Connect current meter to PCB pin 4 (center pin) and pin 7 (left pin).
-Press switch S101 and adjust generator current with potentiometer R114 to the applicable current:
CO = 13 mA; Cl2 = 0,3 mA; NO2 = 5 mA
9Solder the wires of the generator cell and the fan to the PCB pins:
-black cable to pin 4 (center pin)
-yellow cable to pin 7 (left pin)
-red cable to pin 3 (right pin)
10Close the housing of the generator and tighten the screws in the back.
Note:
)Whenever you have done maintenance work on a gas generator, test the function with a working gas detector. The detector should give an alarm within 10 seconds.
12
