4-30 Chapter 4: Appendix G - Factory Settings

Appendix G: Factory Settings

This section summarizes the factory settings for the following Intellicon-NT960/PCI hardware components:

„Intellicon-NT960/PCI Host Adapter

„Intellicon-NT960/PCI ACM/16, ACM/16RJ and ACM/Flex16

„ACM/Flex16 RS-485 SLIM

WARNING

Do not use a pencil to set the DIP switches as the lead graphite may short-circuit the switch.

Your Intellicon-NT960/PCI adapter, ACM/Flex16 and Serial Line Interface Module (SLIM) are very sensitive to static electricity. Make sure that before you remove them from the anti-static shipping bag, you wear an anti-static wristband. When you remove them from the anti-static bag, handle them only by the edges and place them on the anti-static bag or an anti-static mat.

NT960/PCI Host Adapter

The NT960/PCI Host Adapter ships with factory settings for the following:

Table 9: NT960/PCI SW1 factory settings

Switch Position

ON

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1

2

 

3

 

4

 

5

6

SW1

Configuration

Switch 6 on DIP switch block SW1 set on. One to 8 ACM modules stacked together, with only one bus cable between the NT960/PCI Host adapter and the first ACM module.

Note:

Switches 1 through 5 are set off and must not be changed.

Intellicon-NT960/PCI User's Manual, ver. 0.02