Synergy.doc

function. In the remote's TV mode, this button changes the Input Source (Input 1, Input 2...) on your TV. In the remote's VCR mode, this button changes the TV / VCR Input on your VCR.

You can program this button so that in the remote's Cable mode, [INPUT] will operate the Input function on your TV or VCR, eliminating the need to change modes on the remote.

To program [INPUT] to operate your TV Input function in the remotes cable mode...

1.Press [INPUT], then [OK] together until the [CBL] button illuminates.

2.Press [TV]. The [CBL] button will blink 3-times and go out.

Note: You can also press [VCR] in step 2 above to operate the TV / VCR function on your VCR. Or press [CBL] to return to the normal CBL Video Source function.

13. Reset

To reset your remote control to its factory default settings…

1.Press [CBL], then [OK] together until the [CBL] button illuminates.

2.Press [MENU], then [MENU] again. The [CBL] button will blink 3 times and go out.

Reset returns the ALL SmartKey®, Volume / Mute, Mode Lock™ features to their factory default settings.

14.Additional Programming Information, Troubleshooting, Terms

Additional Programming Information

1.The power / mode buttons will illuminate in slow-rotation (i.e. CBL Æ TV Æ VCR Æ DVD Æ AUDIO Æ CBL…) while the remote is in a programming mode. In the absence of a keypress entry, the power / mode buttons will stop illuminating after 45 seconds and the remote will exit the programming mode.

2.When programming the remote control using the [CH +] or [CH -] buttons (Power function) in the Point and Press® Programming method, you may find a code that turns a device off but not back on. If this happens…

a.The correct code has not been found as you may have a code that operates some but not all of the functions of your device. Continue pressing [CH +] until your device turn on.

OR

b.You may have gone past the correct matching code. Try pressing [CH -] one press at a time until you find a code that turns your device back on.

3.When using the Point and Press® Programming method, you can also program your remote using buttons other than the [CH +] or [CH -] as described in Section 5 as follows:

a.[VOL +] – to “go forward” through the codes using the “VOL +” function on your devices.

b.[VOL -] – to “go back” through the codes using the “VOL -“ function on your devices.

Note: When you find the correct code, the volume of the device being programmed will increase or decrease.

c.[S] - to “go forward” through the codes using the “CH +” function on your devices.

d.[T] - to “go back” through the codes using the “CH –“ function on your devices.

Note: When you find the correct code, the channel of the device being programmed will increase or decrease.

e.[XX] - to “go forward” through the codes using the “Fast Forward” function on your devices.

f.[WW] - to “go back” through the codes using the “Rewind” function on your devices.

-13 -

Page 13
Image 13
Contec RT-U62CD operating instructions Reset, Additional Programming Information, Troubleshooting, Terms