3. Hardware Installations
SEH-9450-LAS 17
IDE port Connector: IDE1 This product provides a bus-mastering PCI IDE interface. This interface support PIO Mode 3, PIO
Mode 4, ATAPI devices (e.g., CD-ROM), and Ultra DMA/33/66/100 synchronous-DMA mode transfers.
The BIOS supports logical block addressing (LBA) and extended cylinder head sector (ECHS) translation
modes. The BIOS automatically detects the IDE device transfer rate and translation mode.
After connecting the single end to the board, connect the two plugs at the other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by setting its jumper
accordingly. Please refer to your hard disk documentation for the jumper setting.
Table 3.8. Primary IDE Connector (IDE1)
IDE1
1
2
39
40
PIN No. Function PIN No. Function
1 RESET 2 GND
3 D7 4 D8
5 D6 6 D9
7 D5 8 D10
9 D4 10 D11
11 D3 12 D12
13 D2 14 D13
15 D1 16 D14
17 D0 18 D15
19 GND 20 NC
21 DREQ 22 GND
23 IOW 24 GND
25 IOR 26 GND
27 IORDY 28 ALE
29 DACK 30 GND
31 IRQ 32 NC
33 A1 34 PDIAG
35 A0 36 A2
37 CS1 38 CS3
39 HD ACT 40 GND