MS185,MS185W I.S.
ENGLISH
How to operate your fixture
Step 1: Move slide switch on bottom of the sen- sor to “TEST”. Set sensitivity knob to medium (halfway) (L).
TEST 4 MIN 12 MIN SENSITIVITY
Step 2: Turn on the power to fixture. Allow fix- ture to warm up approximately 40 sec- onds before testing. (Lights will come on and stay on during
period.)
THIS IS THE
BOTTOM SIDE
OF THE MOTION
DETECTOR
L
Step 3: Aim sensor head toward desired detection area, maintaining a 15° down angle to allow moisture to drain. NOTE: Maintain air spacing between lamps and sensor head, at least 1”. Make sure sensor head is positioned with control switches facing towards the ground.
Step 4: Walk across the detection zone at the farthest distance you wish your detector to detect motion.
Step 5: Adjust sensitivity until you get desired results. Lights will turn off 4 sec- onds after all motion stops.
Step 6: Move slide switch to 4 MIN or 12 MIN (AUTO mode). At dusk, lights will operate in the AUTO setting.
How to select your desired feature
Mode of | Set slide switch | How to set | |
operation: | on sensor to: | power switch: | |
Auto Setting | 4 MIN |
| |
(motion activated) | Keep the power to | ||
Lights should turn on with | or | ||
12 MIN | the fixture on. | ||
motion only at night and | |||
|
| ||
should turn off after |
|
| |
4 or 12 minutes. |
|
| |
|
|
| |
Dusk to Dawn Setting | 4 MIN |
| |
(activated only at night) | Turn power on and off twice | ||
Lights should stay on from | or | ||
12 MIN | within 3 seconds. | ||
dusk to dawn and then reset | |||
|
| ||
to the auto setting next |
|
| |
dawn. |
|
| |
|
|
| |
Standard Floodlight |
|
| |
Setting | TEST | Turn power on and off twice | |
Lights should stay on | |||
| within 3 seconds. | ||
continuously both day and |
| ||
|
| ||
night (must be reset |
|
| |
manually). |
|
| |
|
|
| |
Test Setting |
|
| |
Lights should turn on with | TEST | Keep the power to the | |
motion both day and night. | |||
| fixture on. | ||
Lights should turn off after |
| ||
|
| ||
4 seconds. |
|
| |
|
|
| |
Return to Auto Setting | 4 MIN | Turn the power “OFF” for at | |
(motion activated) | |||
From any of the above | or | least 40 seconds., then | |
12 MIN | back “ON”. | ||
settings. | |||
|
| ||
|
|
|
4
