TM
INSTALLATION INSTRUCTIONS
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
Epic/Pole Mounted
Fixtures
Sheet 1 of 4
2/18/04 IMI-575
General: Upon receipt of fixture thoroughly inspect for any freight damage, which should be brought to the attention of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the housing to assure you have received the correct merchandise.
Safety: This fixture must be wired in accordance with the national electrical code and applicable local codes and ordinance. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under installation section. All work should be done by a qualified electrician.
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
ARM & FIXTURE INSTALLATION
Bishop Arm
&
1.Secure arm onto pole and orient.
Bishop Arm
2. Tighten the six set screws located near bottom of arm to 150 in/lbs. to secure arm.
3. Loosen the three arm cap set screws and remove arm cap.
Arm Cap 
Fixture Screws
Teflon Washers
4.Pull fixture leads through arm to arm cap location.
5.Raise fixture to arm aligning locating pin and socket. See Figure 2.
6.Insert and tighten 4 fixture screws with Teflon washers, provided in polybag, to 80 in/lbs.
7.Connect fixture leads to service leads.
8.Resecure arm cap with arm cap set screws tightened to 50 in/lbs.
Traditional Arm
See Figure 3.
1.Slip arm onto pole and orient.
2.Tighten the six set screws located near bottom of arm to 150 in/lbs. to secure arm.
3.Loosen the three arm cap set screws and remove arm cap.
4.Pull fixture leads through arm to arm cap location.
5.Raise fixture to arm aligning locating pin and socket. See Figure 2.
6.Insert and tighten 4 fixture screws with Teflon washers, provided in polybag, to 80 in/lbs.
7.Connect fixture leads to service leads.
8.Resecure arm cap with arm cap set screws tightened to 50 in/lbs.
Arm Cap 
Set Screws
Set Screws
Fig. 1
Modern Top
Aligning Pin 
Aligning Socket
Fig. 2a
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269
