INSTALLATION
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Remove mounting bracket from heater carton.
Figure 5 - Mounting Bracket
Removing Front Panel Of Heater
1.Remove the four screws, two on each side of front panel.
2.Pull front panel forward from the bottom, only 2 to 3 inches (5 to 7.6 cm).
3.Reach into lower right corner of heater and disconnect ignitor wire.
4.Lift panel up to remove, set aside.
5.Remove any remaining packaging materials.
4.Turn front panel face down. Gently press onto a hard surface to snap bushing into hole. Turn panel back over, face up.
5.Place spacers over 4 holes on front panel as shown in Figure 7.
6.Position glass on top of spacers, aligning holes. Note: If glass gets scratched or marred from normal use, it may be reversed on heater.
7.Place 4 retaining clips on glass over holes.
8.Install screws in each hole, but do not tighten at this time.
9.Square glass up with top front surface of front panel. Tighten screws.
10.Snap screw covers over retaining clips.
Screw Cover | Bushing |
| |
Retainer Clip |
|
Front Panel | Ignitor | |
|
| |
| Screw | Wire |
|
| |
Figure 6 - Removing Front Panel Of Heater | ||
Installing Glass Panel |
| |
Items needed from hardware packet: |
| |
1 | - Bushing |
|
4 | - Black spacers |
|
4 | - Retaining clips |
|
4 | - 1.5" long screws |
|
4 | - Screw covers |
|
1.Locate hardware packet and dark acrylic glass.
2.Peel protective coating from both sides of glass.
3.Snap bushing into center front hole of front panel (see Figure 7).
Glass Panel | Spacer | Front |
| ||
| Screw | Panel |
|
| |
Figure 7 - Installing Glass Panel | ||
Methods For Attaching Mounting Bracket | ||
To Wall |
|
|
Only use last hole on each end of mounting bracket | ||
to attach bracket to wall. These two holes centers are | ||
13 inches (33 cm) apart. Attach mounting bracket to | ||
wall in one of two ways: |
|
|
1.Attaching to wall stud
2.Attaching to wall anchor
Attaching to Wall Stud: This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to Wall Anchor: This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level.
www.desatech.com | 9 |
