INSTALLATION INSTRUCTIONS
IMPORTANT : READ CAREFULLY BEFORE INSTALLING FIXTURE.
Tribute
Sheet 1 of 4
1/7/08IMI-685
WARNING: Risk of Fire/Electric Shock. If not qualified, consult an electrician.
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
WARNING: Risk of Burn. Disconnect power and allow fixture to cool before changing bulb or handling fixture.
WARNING: Risk of Personal Injury. Fixture may become damaged and/or unstable if not installed properly. Tighten all fixture components to their recommended torque values. Ensure door is properly latched.
WARNING: Risk of Fire/Electrical Shock. Upside down installation can result in overheating or accumulation of water in fixture. Install right side up.
Tools Required Socket, 5/16" Socket, 3/4" Deep Well Socket, Electrical wiring tools.
FIG. 1
NOTE: these luminaires are designed for outdoor lighting services, and should not be used in area of limited ventilation or in high ambient temperature enclosures. Construction is suitable for down lighting only. Best results will be obtained if installed and maintained according to the following recommendations.
1. Open housing door by squeezing thumb latch towards front of housing. To relieve latch pressure, compress gasket by pushing door into housing. Once the latch is disengaged, gently swing the door open. FIG. 1
2. Remove the door by opening it to 45° angle “half open/half closed” then lift it off the hook shaped hinges. FIG. 2
3. Remove the electrical compartment cover.
Latch
Hard Mount Version
FIG. 2
• Hard mount electrical covers requires captive screws “1” & “2” to be loosened. Grab handle and remove cover. FIG. 3a
Power Tray Version
• Power tray version requires captive screw “1” to be loosened. FIG. 3a
• Grab handle and open power tray. FIG. 3b
• To remove power tray from housing, unhook pin through gap in power tray. Slide off of back pin and unplug the electrical connection. FIG. 3c
| Open |
|
FIG. 3b | Power | FIG. 3c |
Tray |
FIG. 3a | Screw “1” | Handle |
|
Screw “2”
Lift
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
NOTE: Specifications and dimensions subject to change without notice
Visit our web site at www.cooperlighting.com
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 ADH070937
