INSTALLATION INSTRUCTIONS
IMPORTANT : READ CAREFULLY BEFORE INSTALLING FIXTURE.
Tribute
Sheet 3 of 4
1/7/08IMI-685
4c. Slipfitter Mount (FIG. 4c)
•The integral slipfitter can be mounted on 2" (2 3/8" O.D.) pipe. Set screws and a thru bolt are provided to clamp it securely to the tenon. Thru bolt will require a drilled hole thru the arm or tenon. Use the slipfitter as a pattern to drill the thru hole. Secure electrical leads from the drill path. Remove slipfitter and clean burrs on tenon from drilled hole. Reinstall the slipfitter. Remove the cover plate from slipfitter and bring leads into compartment. Pull power supply leads and the ground lead into the bottom half of the slipfitter. Be sure the pivot retainer bolt is tightened securely after aiming is accomplished. Tighten all mounting bolts per FIG. 4c.
4d. Trunnion Mount (FIG. 4d)
•If the unit is provided with a trunnion which can be mounted directly on a flat surface (Adapters are available for installation on building fronts, poles, crossarms, pipes, etc.)
5.Socket Setting
•Socket is normally factory set to provide IES Type II light distribution pattern. To obtain IES Type III distribution, proceed as follows (FIG. 5).
•Loosen the two (2) hex head clamping screws sufficiently for the socket to clear the indexing screws.
•Move socket bracket so that the indexing screws engage appropriate indexing holes. See table (FIG. 5) for socket position and resulting light pattern.
FIG. 5
Socket
Mount
Indexing | Indexing |
Screw (2) | Hole |
Clamping
Screw (2)
FIG. 4c (Slipfitter Mount)
Pivot Retainer Bolt Torque to
| |
Set screw | Hex HeadThru Bolt |
Torque to | with lock nut. |
|
FIG. 4d (Trunnion Mount)
| 3 1/2" | ||
(Torque to |
| ||
| [89mm] | ||
3" [77mm] | |||
|
2" [51mm]
5 3/8" [137mm]
Mounting
Holes
Light Pattern | Socket Index Position | ||
IES Type | 250W Clear HPS Lamp | All other Clear | |
|
| (5 3/4” LCL)* | HID Lamps (5” LCL)* |
| II | A | B |
III | C | D |
NOTE: * Light Center Length.
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
NOTE: Specifications and dimensions subject to change without notice
Visit our web site at www.cooperlighting.com
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 ADH070937