SMALL FALCON DRILL TEMPLATE
NOTE: FOR USE ONLY WHEN INSTALLING CAT. NO. PE/MT PHOTOELECTRIC CONTROL
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before using this template.
Small Falcon
Sheet 7 of 7
1/26/05
Customer First Center • 1121 Hwy 74 South • Peachtree City,
Instructions:
1.Use scissors to carefully cut this template from this sheet.
2.Open luminaire door, rotate latch forward and align this template on top surface of luminaire.
3.Place center punch at target point and procede to center punch the top surface of the luminaire.
4.Remove template and any electrical components and/or wiring located in the areas inside the luminaire where the hole is to be drilled.
5.Drill a 27/32 (.843) inch diameter hole at center punch location. Use several smaller drills first or use a step drill for this process.
6.Remove all burrs at hole both inside and outside of luminaire. Remove all metal chips from inside of luminaire.
7.Install Cat. No. PE/MT using instruction sheet provided with the Photoelectric Control.
Center
Punch
Here
(See Step 3)
GA 30269
WARNING: Risk of fire and/or electric shock. Failure to follow the above instructions may result in personal injury and/or property damage.
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
