Mellennium II - Water Inlet Replacement
MILLENNIUM II
WATER INLET REPLACEMENT
This instruction sheet details the procedure for replacing the water inlet fitting at the valve. All necessary material to make the change, along with this bulletin, is included in a kit. The kit contents are listed below. Note that this kit will work for all models, regardless of volt- age.
| Millennium II - Kit No. 629087501 | |
|
| |
Fitting (Qty. 6) |
| 77050300 |
|
|
|
| 31525003 | |
|
|
|
Clamp (Qty. 12) |
| 40502 |
|
|
|
Tubing (Qty. 18 in.) |
| 50299 |
|
|
|
Instruction Sheet |
| 620919561 |
|
|
|
Procedure
1.Turn off the water supply to the dispenser. Disconnect power from the dispenser. Remove the top panel and merchandiser. Note that there are two harnesses from the top panel and one from the merchandiser that must be disconnected. Make sure to mark the harnesses so as not to incorrectly wire them during
2.Remove the hitch pins that secure the refrigeration deck to the waterbath housing. Carefully lift the refrigeration deck out of the waterbath to access the manifold.
FIGURE 1
3.Remove the water inlet fittings from the back of the valve (Figure 1). These are the fit- tings attached to the
4.If not already done, install the new
5.Turn on the water supply to the dispenser and check for leaks. If any leaks are discov- ered, turn off supply and
6.Install and secure the refrigeration deck into the waterbath, and install the side panels, top panel and merchandiser. Making sure to properly connect the harnesses and interlock all cladding pieces. Do not force any panels together. During proper assembly, the panels will slide together easily and remain interlocked. Connect power to the dispenser.
Release Date: February 2, 2002 | Revision: A |
|
© 2002, IMI Cornelius Inc. | - 1 - | Publication Number: 620919561 |