General Accessory Installation
8Optional Accessories Installation
8.1General Accessory Installation
There are many accessory products available for the Allegiant Series, including key- boards, alarm interface units, control code signal distribution units, etc. If applicable, these products can be installed at the same time as the main CPU bay installation, or postponed until later. In some cases, products are designed to be racked in close proximity to the main CPU bay, so appropriate rack space should be reserved.
Please refer to the instructions supplied with the specific accessory product for com- plete installation details.
8.2Logging Printer Option Installation
NOTE | Although the exact installation procedure for each printer varies, the following | |||
| steps are generally required. Be sure to save the printer reference manual for | |||
| procedures not covered. | |||
| 1. | Switch the main power OFF to the printer. | ||
| 2. | Install the ribbon cartridge and paper if necessary. | ||
| 3. | Set any configuration switches for your particular printer to match the format | ||
|
| provided by the Allegiant system. Note that the system communication protocol | ||
|
| can be changed using the Keyboard User Functions (described later in this man- | ||
|
| ual) with the optional Allegiant LTC 8059 MCS package. The factory default | ||
|
| values are as follows: | ||
|
|
|
|
|
|
| Baud rate | 19,200 |
|
|
|
|
|
|
|
| Stop bits | 1 |
|
|
|
|
|
|
|
| Data bits | 8 |
|
|
|
|
|
|
|
| Parity | None |
|
|
|
|
|
|
NOTE | The required interconnect cable utilizes a custom pinout. Refer to the Appendix | |||
| Section of this manual for wiring details. | |||
4.Attach the
5.Attach the
6.Apply power to the printer.
7.Verify logging printer action by ‘loading’ a previously stored sequence into a monitor, activating an alarm, or performing a system reset. Any of these actions should cause printouts to occur.
EN 19
