7Installation Procedure
7.1Main CPU Bay Installation
Before discarding the shipping cartons, verify that the various pieces of equipment have no evidence of carrier damage.
CAUTION | Do not apply power to the equipment until instructed to do so. |
1.Remove the front panel of the main CPU bay by loosening the four (4) corner fasteners.
2.Install the power supply in far right position of the main CPU bay insuring proper alignment and seating of the module into the rear mating connector. Ver- ify that the power supply ON/OFF switch is in the OFF position.
3.Install the four (4) screws and star washers (supplied) on the rear panel of the bay(s) surrounding the power supply line cord to fasten the power supply securely in place.
CAUTION If the Allegiant card cage is to be transported, the main power supply should be removed to prevent possible damage to the bay's internal parts.
4.If the bay(s) are to be installed into a standard
7.2Video Input Modules
Termination switches on the Video Input Modules (VIM) must be set to the correct position prior to installation. If necessary, see Section 7.6 “Termination Practices,” on page 18 prior to actually installing the VIM on this system.
The appropriate number of VIMs should be installed in the main bay starting with the left most slot. If less than full capacity is being used, the modules should be inserted in a
Figure 3: Typical Video Input Module Insertion
The VIMs are identical and are interchangeable within the designated VIM slots without having to make any changes to the module.
EN 16 | Bosch Security Systems December 13, 2005 |
