CPU Software Version Numbers
Appendix B Installation Checklists
A simplified guide for those who are already familiar with installing and program- ming Allegiant systems.
MAIN BAY HARDWARE INSTALLATION
✔ | Unpack equipment and verify that items have been received without carrier damage. |
|
|
✔ | Install power supply (do not turn ON) and CPU module. |
|
|
✔ | If applicable, install bay into EIA |
| foot pads. |
|
|
✔ | Install video input module(s) following proper termination procedures. Install video |
| output module(s). |
|
|
✔ | Connect camera inputs and monitor outputs to appropriate connections on equip- |
| ment bay(s). |
|
|
✔ | Connect system keyboards, any alarm interface unit(s), and any signal distribution |
| unit to the main bay. |
|
|
✔ | Set CPU DIP switches to activate desired features. |
|
|
✔ | Apply main AC power to equipment. |
|
|
✔ | Verify system is operating properly then begin appropriate programming. |
|
|
PROGRAMMING VIA SYSTEM KEYBOARD
✔Enter system time (User Function 7) and date (User Function 8). Enter Camera ID titles (User Function 9), and if desired, adjust monitor overlay displays (User Function
4, 5, & 6 or 24, 25 & 26).
✔Enter desired Sequences.
✔Configure and test alarm response mode.
SATELLITE CONFIGURATION HARDWARE INSTALLATION
Main Site:
✔Install main Allegiant bay and appropriate accessory products accordingly. Verify the biphase control code line is run to each satellite site.
✔Attach trunk line inputs, local camera inputs, and monitor outputs to the main Alle- giant bay. Apply main AC power to equipment.
✔Program Camera ID Table using the LTC 8059 MCS package.
✔Switch all unused monitor outputs located at the main site to display a 'local' cam- era input.
Satellite Site(s):
✔Install satellite switcher and appropriate accessory products accordingly.
✔Connect the biphase code line to the LTC 8780 Data Converter unit and configure according to the desired satellite address and switcher's baud rate.
✔If necessary, program the satellite switcher for the desired camera titles and any other related requirements.
EN 85
