Wall Stud
Cut access hole alongside stud and feed wires though hole.
Approximate Stud line Behind Wall
Wall
Hex Cap Screw
Bend wire to line up with access
hole in plate.
Wall Mount Assembly
Figure 7 — Install wall mount assembly
NExtron recommends that the wiring installation be performed by a professional audio equipment installer.
5. | Using compatible speaker wire (Extron recommends using |
| |
| speaker location by the most convenient and safe route. If |
| the wiring is to remain hidden behind the wall, follow the |
| stud to where the small access hole has been cut, and feed |
| about two feet of wire out through the hole into the room. |
| If necessary, bend the wire to align with the plate (see |
| figure 7). Secure the wire to the stud at various places, but |
| allow enough freedom of movement near to the hole for |
| connection to the speaker. |
6. | Pull sufficient wire up through the holes in the rear plate |
| (see figure 8) to allow ease of connection to the speaker |
| after installation. |
NDo not strip and connect the wire at this time.
Pass the wires through the plate access hole.
Figure 8 — Pass the wire through the plate
SI 26 and SI 28 Speakers • Installation | 5 |