Anchor this end to a suitable secure point.
Seismic Safety Cable
Attach line here and secure.
Figure 10 — Attach a seismic safety cable to the rear of the speaker
Mounting the SI 26 speaker onto the wall mount assembly
3. | Carefully lift the speaker above the wall mount assembly |
| and gently slide the speaker box bracket down into the V |
| lock groove (see figure 11) until it locks into place. |
Lift the speaker up to the
wall mount assembly....
Box
Bracket
VLock Groove
...and slide it down into the
Box
Bracket
V Lock
Groove
Figure 11 — Slide the speaker down onto the wall mount assembly
4.Repeat steps 1 through 3 for the second speaker, then proceed to "Wiring the SI 26 and 28 speakers" section on page 8.
Mounting the SI 28 speaker onto the wall mount assembly
3a. Carefully lift the speaker up as close to the bottom of the wall mount assembly as possible and hook the right outer edge of the speaker box bracket over the right inner edge of the
NHolding the speaker so that the lowest part of the speaker is as close to the bottom of the
SI 26 and SI 28 Speakers • Installation | 7 |