Installation, cont’d
shown in figure 5 and tighten the hex cap screw to lock the plate in position. This makes the next steps easier to perform.
Rotate this section 90°.
Fasten the
wall mount plate to the vertical surface (see step 7).
Figure 5 — Rotate and mount the wall mount assembly
3. Mark the location of the wall mount plate's three primary mounting holes on the stud line, and drill pilot holes.
NFor some surfaces the four alternative pilot dimples (see figure 6) may be used to secure the assembly in place. Mark and drill as appropriate.
Alternative
Pilot Dimples
Primary
Mounting
Holes
Alternative
Pilot Dimples
Figure 6 — Mounting hole locations on the speaker bracket
4.Mark the wall where the wire will pass through the plate, and cut a small access hole large enough for the wire to pass through without snagging. If the stud is wider than the plates access hole, then cut the hole in the wall to the left or right and directly alongside the stud (see figure 7).
NBefore cutting it, make sure the plate will hide the proposed area of the hole after installation.
