8.3Computer Interface Installation
NOTE | Although the exact installation procedure for each computer varies, the follow- | |
| ing steps are generally required. Be sure to save the computer reference man- | |
| ual for procedures not covered here. Switch the main power OFF to the | |
| computer. | |
| 1. | If using an Allegiant software package, attach the PC security key provided with |
|
| the software to an available port on the computer. |
|
| The supplied interconnect cable utilizes a custom pinout. If it ever becomes nec- |
|
| essary to replace the cable, it can be ordered separately using part number: |
|
| LTC 8506/00. Alternatively, a cable can be configured using the information |
|
| found in the Appendix Section of this manual. |
| 2. | Attach one end of the supplied |
|
| CPU bay connector marked Console (or another port that has been configured |
|
| to operate as a console port). |
| 3. | Attach the other end of the cable to an available serial port (COMM PORT 1 |
|
| or COMM PORT 2) on the rear of the computer. |
| 4. | Apply power to the computer and allow it to boot up its operating system |
|
| before inserting the software disc. |
| 5. | Refer to the applicable Allegiant software manual for complete programming |
|
| instructions. |
EN 20 | Bosch Security Systems December 13, 2005 |
