OPERATORS INSTRUCTIONS
This section covers operating controls, daily
WARNING: Disconnect electrical power from the Cooling Unit to prevent personal injury before attempting any internal maintenance. Only qualified personnel should service internal components or electrical wiring.
OPERATING CONTROLS
(see Figure 3)
COOLING UNIT POWER SWITCH
Cooling Unit power switch, located on syrup inlet line connection side of the unit, must be in the “ON”(up) posi- tion before the unit will operate.
COOLING UNIT CIRCULATING PUMP POWER SWITCH
Carbonated water circulating pump power switch labeled CIRC MOTOR, located on electrical box under hood, must be in “ON”(up) position before motor will operate.
COOLING UNIT CARBONATOR MOTOR POWER SWITCH
Carbonator motor power power switch labeled CARB MOTOR, located on electrical box under hood, must be in “ON”(up) position before carbonator will operate.
DAILY PRE-OPERATION CHECK
1.Make sure CO2 cylinder primary CO2 regulator assembly
2.Sufficient syrup supply in all syrup tanks. If not, replenish syrup supply as instructed.
11 | 312021002 |