STEP 2:

The ember tray and rear burner assembly are now ready for installation. This assembly includes steel tray framing, the rear burner assembly, including the gas tube. Refer to FIGURE 7 to view the installation of these parts. The installation is in the direction of the arrows shown in FIGURE 7.

FIGURE 7: BURNER INSTALLATION, STEP 2

FIGURE 8 shows the rear burner tray assembly installed and sitting properly in the bottom of the Inglenook Fireplace. Note that the gas tube of the rear burner must go through the slot in the right side of the floor and sit on top of the rear burner orifice mounted to the lower gas line. FIGURE 9 shows a close-up view of the rear burner adjustable shutter gas tube being set over the gas orifice. It is important that the person performing the installation ensure that the rear burner adjustable shutter tube is located properly over the rear orifice. If the tube is not placed properly over the orifice, the burner assembly will not sit correctly into the Inglenook Fireplace.

FIGURE 8: STEP 2 COMPLETE

FIGURE 9: GAS TUBE

Version 1.0b

13