Reassembling the Mow-BallSupport Assembly

WARNING! Before performing any maintenance procedure, stop the engine and disconnect the spark plug wire.

Important: Improper installation can cause damage to your machine’s bearings. Following these directions carefully will protect your machine from damage.

Reassemble the components in the order shown in Figure

21

1.Position the backup plate with the curve facing up. (Figure 21)

2.Stack the line plates on top of one another with the bumps on the bottom locking into the grooves on top of each plate.

3.Place the head of the Mow- Ballbolt so it is sitting in the groove at the bottom of the Mow-BallSupport.

4.Hold the bolt head in place with your finger and turn the Mow-BallSupport assembly clockwise until it is finger tight.

Figure 21

DR® TRIMMER/MOWERSafety & Operating Instructions

27

Page 31
Image 31
Country Home Products Men's Trimmer operating instructions Reassembling the Mow-BallSupport Assembly