HOW TO USE
Air quality sensor
The product is initially set in standard sensitivity. You can adjust sensor sensitivity as like the following methods when humidity is high, when purity level lamp operates more than 2 hours even not in the case of severe yellow sand and when purity level lamp keeps green more than 1 hour in the case of high indoor pollution.
CLEANING METHOD
-Make sure to take power plug out prior to filter cleaning.
-Do not use volatile matter or detergent, etc.
-Do not put the product in water or spray water.
Cleaning the air quality sensor (Every 2 Months)
Safety Information
�On the condition of operation, press airflow selection / mode selection button more than 2 seconds at the same time.
�Purity level display lamp on the front side
twinkles in yellowish green color.
●Clean the air inlet and outlet using a vacuum cleaner or soft brush.
●Open the particle sensor cover on the right side of the unit (when facing the unit). Use a wet
cotton swab to clean and dry the lens, dust inlet and dust outlet.
outlet | air inlet |
|
|
|
|
dust outlet
�
Operating Instructions
�Adjust to desired sensor sensitivity by pressing
airflow selection button. Sensor sensitivity displayed by twinkling mode display lamp.
Insensibility Standard Sensibility
Rhythm Infant Automatic
�If press airflow selection/modes election
button again more than at the same time, the product starts working normally and sensor sensitivity input.
If there is no button input for 10 seconds, the value input automatically.
17
dust inlet
Cleaning the air intake and outlet
●Clean the air intake and outlet with a soft
brush.
Be careful not to drop the brush into the unit.
Cleaning the negative ion generator (Every 2 Months)
●Use a dry cotton swab to remove dust on the plate.
Be careful not to drop the cotton swab into the unit.
18
Troubleshooting Tips Customer Service