HOW TO START YOUR RIDER COOLING SYSTEM
•With the tractor key in "ON" position,
toggle power switch on unit to "ON" posi- tion.
NOTE: It is normal to experience a delay from the time the system is turned on to the deliv- ery of mist from the nozzle. If this exceeds 2 minutes, refer to the troubleshooting section.
HOW TO STOP YOUR RIDER
COOLING SYSTEM
•Toggle power switch on unit to "OFF" position.
NOTE: The system will continue to mist after the system is turned off. The system will stop misting after the water and air lines have been cleared.
HOW TO REFILL YOUR RIDER
COOLING SYSTEM
•Switch power switch on power unit to the "OFF" position.
•Allow system to vent. System is ready to fill when air can no longer be heard coming from misting head.
•Remove fill cap on power unit and fill through basket filter with DRINKING WATER ONLY.
•Replace cap and hand tighten.
ADJUSTING MIST DENSITY
•To optimize the cooling effectiveness of the system, the adjustment valve offers unlimited variation of mist density from closed to fully open.
•To increase the mist density, turn valve counterclockwise.
•To decrease the mist density, turn valve clockwise.
•Once you are satisfied with the setting of your mist density, use the locking nut on the adjustment valve to save your setting.
OPERATING TIPS
•Never use any liquid other than DRINKING WATER in the system.
•For dry climates, increasing the water
flow will provide maximum cooling re- suits. In humid climates, a reduced water flow is recommended.
•Adjust the misting nozzle direction to maximize contact with exposed skin during operation.
]5
