Usingsupplied9/16"drillbit(DD),drillhole throughthedashatthebottomofthe mountinglocationUsecautionnotto. damageanythingtheenginecom- partmentwhiledrillinghole.
•Proceed to Step 2.
Step lb (Tractors w/o mounting locations)
•Open tractor hood and ensure that no wires or cables are located at the bottom
of potential mounting locations. If wires or cables are present, temporarily clear the area by securing them safely away from mounting location using a supplied cable tie (d).
•Evaluate dash for best location to mount
misting arm. Ensure that the chosen loca- tion will not limit the functionality of the tractor or interfere with closing of the hood.
•Mark desired location.
•Prior to drilling, take precautions to protect engine compartment from drill shavings.
•Using supplied 9/16" drill bit (DD), drill hole through the dash at the desired mounting location. Use caution not to damage anything in the engine compartment while drilling hole.
•Remove drill shavings and clean area surrounding mounting location.
•Proceed to Step 2.
Step2
•Install rubber washer (H) onto the misting arm assembly (BB), by sliding over hoses and threaded section until seated against mounting flange.
•Feed supply lines of nozzle holder assem- bly (BB) through hole drilled in step 1 .
From inside the engine compartment, pull supply lines through hole until the flange of the misting nozzle assembly (BB) is seated on the surface of the dash. Threaded portion of adapter should now extend into the engine compartment at mounting location.
