Connecting Power Unit to
Misting Arm Assembly
Step 1
•Locate supply lines and power connector at the power unit (AA) and uncoil to full length.
Starting at the rear of tractor, feed supply lines and connector assembly underneath tractor body along right side of chassis using care to avoid any potential interfer- ence with tractor functionality.
IMPORTANT: To ensure lines will not be damaged during tractor use, it is recommended that you follow the exact path of existing electri- cal supply lines installed on your lawn tractor.
Step 2
•When the supply lines have exited the underside of the tractor body, feed the supply lines and power connector along tractor chassis into engine compartment.
WARNING: Engine components may be hot. Exercise caution when working in engine com- partment to avoid personal injury.
Continue to feed lines through the engine compartment to the other side of the trac- tor. Ensure that the supply lines are routed safely away from the engine by routing behind existing cables and wires.
NOTE: Do not install routing clips (G) at this time. The lines are only run to make the con- nection at this point in the installation. Finaliz- ing installation will occur in subsequent steps.
