Craftsman 139.53674SRT Install the Door Control, Hardware Shown, DryWaAnchom, Backview

Installation Step 6

Install the Door Control I

Locate the door control within sight of the door at a minimum height of 5 feet where small children cannot reach, and away from all moving

)arts of the door and door hardware.

The door control is typically attached directly to the wail. If installing into drywall, drill 5/32" holes and use the anchors provided. For pre-wiredinstallations (as in new home construction), Console models may be mounted to a.standard single gang box (Figure 2).

1.Strip 1/4" of insulation from one end of the bell wire and connect it to the two screw terminals on

the back of the door control: white to 2 and white/red to 1.

2.Door Control Button: Fasten securely with 6ABx1-1/2" screws.

Console Model: Pry off cover along one side with a screwdriver blade (Figure 1). Fasten with 6ABx1-1/4" self-tapping screws (standard installation) or 6-32x1" machine screws (pre-wired installation) as follows:

•Install bottom screw, allowing 1/8" to protrude above wall surface.

•Position bottom of door control on screw head

and slide down to secure. Adjust screw for snug fit.

•Install top screw with care to avoid cracking plastic housing. Do not overtighten.

•Insert top tabs and snap on cover.

3.(For standard insta/lation only) Run the bell wire up the wall and across the ceiling to the opener. Use insulated staples to secure the wire in several places. Be careful not to pierce the wire with a staple, creating a short.

4.Connect the bell wire to the terminal screws on the opener panel: white to 2; white/red to 1.

5.Positionthe antenna wire as shown.

Do not connect to live electrical widng. Connect

only to 24 Volt low voltage wires. Connection to live wires or higher voltage may cause serious injury from shock, burn or electrocution.

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death.

Install the door control (or any additional push buttons) out of the reach of children and away from all moving parts of the door and door hardware, but where the garage door is visible. Do not allow children to operate the push button(s) or the remote control(s).

A moving garage door could injure someone under it. Activate the opener only when the door is properly adjusted, you can see It clearly, and the.re are no obstructions to door travel.

	Hardware	Shown
6AB x 1-1/2"Screw	Actual	Size
DoorControlButton
Contxo4Console(std instaltadon)		Staples
ControlConsoleLore-wired)	DryWa_Anchom
Figure 1	Figure 2
REMOVE & REPLACECOVER	PRE-WIRED
	INSTALLA'RON

24 Volt

2-Conducto¢ BellWire

STANDARD CONTROL

	(BACKVIEW)
	Top
DOOR CONTROL	T_nal
BUTTON (BACK)

PREMIUM CONTROL

(BACKVIEW)

Wire

Top

DOORPREMIUM

CONTROL STANDARO CONTROL

BuTroN CONTROLCONSOLE

CONSOLE

BackPanel orOpener

Terminal Screws

_Te_Nnal

_1 ''_=_ >scfewt

Be.. [.__ .Mou_ng

W'ffm _.HO_

18