OPERATION cont.
CHARGING THE BATTERY PACK cont. (Fig. 5 and 5a)
8.The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
9.Do not place the battery charging stand / transformer in an area of extreme heat or cold. It will work best at normal room temperature.
10.When battery pack becomes fully charged, unplug battery charging stand / transformer from power supply and remove the battery pack.
CHARGING A HOT BATTERY PACK
When using your tool continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge.
NOTE: A hot battery pack only occurs when prolonged continuous use of your drill/driver causes the batteries to become hot. It should not occur with typical use.
OPERATION cont.
TRIGGER SWITCH (Fig. 7 and 7a)
To turn the drill ON, push the Forward / Reverse Selector Switch with Power
Fig. 7 |
| Fig. 7a | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FORWARD | REVERSE |
INSTALLING THE BATTERY |
| |
Fig. 6 | ||
PACK IN DRILL / DRIVER (Fig. 6) | ||
| ||
1. Place the Forward / Reverse Selector Switch |
| |
with Power |
| |
lock the power off. |
| |
2. Place the battery pack in the drill, aligning the |
| |
raised rib on battery pack with groove inside |
| |
the drill. |
| |
3. Make sure the latches on each side of the |
| |
battery pack “snap” into place, and the battery |
| |
pack is secured in the drill / driver before |
| |
beginning operation. |
|
VARIABLE SPEED (Fig. 8)
The variable speed trigger switch delivers
higher speed and torque with increased pressure on the trigger switch and lower speed and torque with decreased pressure on the trigger switch.
NOTE: You might hear a whistling or ringing noise from the trigger switch when operating at low speeds. Do not be concerned; this is a normal part of the switch function.
7 |
5 |
3 |
1 |
Fig. 8 |
!CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installation of the battery pack can cause damage to internal components.
!WARNING: Cordless Battery Tools are always in operating condition when the battery pack is installed in the tool. Therefore the Forward / Reverse Selector Switch with Power
16 | 17 |
