•Place the cable barrel fitting into the hole in the trigger. You can find the triggers and associated hardware in group H of the hardware pack. See Figure 12.
Trigger
Assembly
Trigger Cable
Cable Tie
Inner Cable
Cable
Trigger Housing
Figure 14
Barrel |
|
| |
Slot | |||
Fitting | |||
| Cable snaps in at | ||
|
| this end | |
Figure 12
•Pull on the cable and rotate it around the bottom of the trigger, with the inner cable in the slot, until the cable end can be pushed into the trigger housing and snapped tight. See Figure 12.
NOTE: When the cable is installed correctly, you should not be able to pull the cable out of the trigger housing.
•Place the right turn trigger in position underneath the right handle. Secure with screw and weld nut from group H of the hardware pack. See Figure 13. You will need a phillips screwdriver for tightening the screw. Repeat on left side.
Secure with screw
Weld Nut
Turn
•Secure the left turn trigger cable to the lower handle using the other cable tie. Make sure to route the cable tie below the auger drive cable so that when the trigger cable is secured by the cable tie, the auger drive cable is left outside the cable tie. Trim excess ends from each cable tie.
NOTE: The right side cable tie must be used to keep cable from coming in contact with the moving shift arm from the transmission.
Lamp Wiring
•Wrap the wire from the lamp down the right handle as shown in Figure 15.
•Plug wire into the alternator lead wire under the fuel tank. See Figure 15.
Trigger Cable
Handle
| Alternator |
Lamp | Lead |
| |
Wire |
|
Slot
Trigger
Trigger
Cable
Figure 15
Figure 13
•Secure the right turn trigger cable to the right lower handle using cable tie provided in the hardware pack. Make sure not to wrap the drive cable. See Figure 14.
10
IMPORTANT: Assemble your snow thrower, then check the adjustments as instructed and make any final adjustments necessary before operating the unit. Failure to follow these instructions may cause damage to the snow thrower.
