Grizzly G1073/G1073Z instruction manual Wiring The Motor Belt, To install the V-belt

Wiring The Motor V-Belt

1.The Model G1073/G1073Z motor and ON/OFF switch each have a special connec- tor for ease of wiring. Plug the connectors into each other as illustrated in Figure 7.

2.The motor is prewired for 220 volt operation. Install the appropriate 220V plug onto the power cord.

3.If 110 volt operation is desired and you are inexperienced with wiring, contact our Service Department for further information.

4.A wiring diagram is located on Page 31 of this manual to further assist you with wiring details.

Figure 7. Plugging cords together.

To ensure optimum power transmission from the motor to the band wheels, align the pulleys, and tighten the V-belt.

To install the V-belt:

Slip the V-belt over the motor pulley and step pul- ley. Position the V-belt on the pulleys according to the speed you want (see Figure 8 for speed chart). For general woodworking, we recommend the fastest blade speed.

Figure 8. Pulley speed chart diagram.

-12- G1073/G1073Z 16" Bandsaw