Lubrication
For a view of the lubrication points on the snow thrower, see Figure 20.
Sprocket Shaft
•Lubricate the sprocket shaft with grease at least once a season or after every 25 hours of operation.
IMPORTANT: Keep all grease and oil off of the friction wheel and the drive plate.
Shifting Mechanism
•Lubricate the shifting mechanism and pivot points on the shift rod with engine oil at least once a season or after every 25 hours of operation.
Traction Drive Control
•Lubricate cams on the ends of the control rods which interlock the traction drive and auger controls at least once a season or every 25 hours of operation with grease. The cams can be accessed beneath the handle panel.
Gear Case
•The gear case is lubricated with grease at the factory and does not require checking. If disassembled for any reason, lubricate with two ounces of Shell Alvania grease.
LUBE
Bearings
•Once a season lubricate the auger bearings and the bearings on the side of the frame with light oil. See lubrication chart below.
Check V-belts
Follow instructions below to check the condition of the drive belts every 50 hours of operation.
•Remove the plastic belt cover on the front of the engine by removing two
•Visually inspect for frayed, cracked, or excessively worn out belts.
Check Friction Wheel
Follow the instructions below to check the condition of the friction wheel rubber every 25 hours of operation.
•Remove the four
•Visually inspect the friction wheel rubber for excessive wear, cracks, or loose fit on the friction wheel drive hub.
•Also engage traction drive control and check if the friction wheel is making contact with the friction plate.
•If it does not make contact, adjust the traction drive cable following adjustment instructions. Recheck the friction wheel.
•Replace friction wheel rubber if necessary. Refer to instructions on page 22.
LUBE
LUBE
Figure 20: Lubrication Chart
18
