SQUARING THE MITER TABLE TO THE FENCE
See Figures 13 - 16.
•Unplug your saw.
_lk WARNING: Fallur_ to unplug your saw could result in accidental starting causing possible
serious personal injury.
Push down on the saw arm and pull out the lock pin to release the saw arm.
Raise sew arm to its full raised position,
Lift the miter table clamp.
Rotate the miter table until the pointer is posi- tioned at 0°.
Push the miter table clamp back down.
Lay a framing square fiat on the miter table. Place one leg of the square against the fence. Place the other leg of the square beside the zero clearance throat plate in the miter table. The edge of the square and the zero clearance throat plate in
the miter table should be parallel as shown in figure 13.
MITER
FENCETABLECLAMP
FRAMING
SQUARE
MITERTABLEZEROCLEARANCE THROATPLATE
ViEWOF MITERTABLESQUAREWITH
FENCEANDCORRECTLYADJUSTED Fig. 13
If the edge of the framing square and the zero clearance throat plate in the miter table are not parallel as shown in figures 14 and 15, adjust- ments are needed.
FENCE
FRAMINGZEROCLEARANCE
SQUARETHROATPLATE
MITERTABLE
ViEWOF MITERTABLE NOTSQUAREWITH FENCE,ADJUSTMENTSARE REQUIRED Fig. 14
FENCE
FRAMINGZEROCLEARANCE
SQUARETHROATPLATE
MITER TABLE
ViEW OFMITERTABLENOTSQUAREWITH
FENCE,ADJUSTMENTSARE REQUIRED Fig. 15
Using a 6 mm hex key, loosen the socket head screws securing the fence. See Figure 16. Adjust the fence left or right until the framing square and zero clearance throat plate are parallel.
6 mm SOCKET _
_ | v | Fig. 16 |
•Retighten the screws securely and recheck the
16
