,_ WARNING: | To prevent accidental starting that | • | Unplug your saw. | |
could cause possible sedous personal injury, |
|
|
| |
assemble all parts to your sew before connecting |
| WARNING: | Failure to unplug your sew could | |
it to power | supply. Saw should never be |
| result in accidental starting causing possible | |
connected to power supply when you are |
| serious personal injury. | ||
assembling parts, making adjustments, installing |
|
|
| |
or removing blades, or when not in use. |
| Push down on the sew arm and pull out the lock " | ||
|
|
| pin to release sew arm. Raise sew arm to its full | |
As mentioned previously your saw has been factory |
| raised position. | Be cautious, saw arm is spring | |
assembled and adjusted. The dust guide and blade |
| loaded to raise. | ||
are the only parts that have to be installed. |
| Loosen the phillips screw on the blade belt | ||
|
|
| ||
DUST GUIDE |
|
| cover until blade belt cover can be raised. | |
See Figure 8. |
|
| See Figures 9, 10, and 11. | |
To install the dust guide, place the end marked |
| Gently raise the lower blade guard bracket, | ||
|
|
| ||
INSERT over the exhaust port in the upper blade | releasing lower blade guard from notch so that | |
lower blade guard and blade bolt cover can be | ||
guard. Turn the guide so that the open end is facing | ||
rotated dp and back to expose the blade belt. | ||
down or toward the rear of the saw. | ||
See Figures 9, 10, and 11. | ||
| ||
EXHAUST | PHILLIPSSCREW | |
PORT | ||
|
DUST GUIDE
Fig. 8
TO INSTALL BLADE
See Figures 9, 10, and 11.
_1= DANGER: A
that is too thick to allow outer blade washer to
engage with the fiats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade screw from securing the blade on the spindle. Either of these situations will result in a serious accident and can cause serious personal injury.
LOWER BLADE GUARD BRACKET
Fig. 9
LOWER
BLADEGUARD
PHIUJPS
SCREW
Fig. 10
13
