Craftsman 315.21208 owner manual Trigger Lock, Bevel Lock Knob

MITER TABLE CLAMP

See Figure 4.

The miter table clamp securely locks your saw at desired miter angles.

SAWARM

TRIGGER LOCK

See Figure 6.

To prevent unauthorized use of your compound miter saw, we suggest that you disconnect it from the power supply and lock the switch in the off position. To lock the switch, install a padlock through the hole in the switch trigger, A lock with a shackle up to 13/64 in. diameter may be used. When the lock is installed and locked, the switch is inoperable. Store the padlock key in another location.

SWITCHPADLOCK

TRIGGER

MITERTABLE

CLAW'ON

Posmo_

Fig. 4

LOCK-OFF LEVER

See Figure 5.

The switch trigger is equipped with a lock-off lever to reduce the possibility of accidental starting. The lock-

Off lever must be pressed down with the palm of your hand to turn the saw on. The spring loaded lever will spring back into the lock-off position when the switch trigger is released.

LOCK-OFF

LEVER

TRIGGER

Fig. 5

_ Fig. 6

POSITIVE STOPS ON MITER TABLE

Positive stops have been provided at 0 °, 22-1/2 ° and 45 °. The 22-1/2 ° and 45 ° positive stops have been

provided on both the left and right side of the miter table.

BEVEL LOCK KNOB

The bevel lock knob securely locks your compound miter saw at desired bevel angles. Positive stop adjustment screws have been provided on each side of the saw arm. These adjustment screws are for

making fine adjustments at 0° and 45 °. See pages 17 and 18.

11