INSTALLINGADHESIVESANDPAPER
See Figure 3.
•Unp]ug thesander.
•Ifreplacingadhesivesandpaper,remove oldsand- paperby peelingitoffcushion.Ifreplacingregular sandpaper, relsase paper C_T_pby liftingup on paper cramp lever and disengagingit from the tab on the platen.
•Remove
•Carefully peel adhesivebacking from new 114sheet sandpaper.
•Positionsandpaper, makingsure front edge of sand- paper is alignedwith front edge of the cushion,then carefully press _cky side of sandpaper on cushion. NOTE: Sandpaper must be a[igned with the front edge of the cushionfor proper functioning of the flush sand- ing feature.
The cushion on the sander ksapprox_nnately
1/4 in. smaller than precut
CUSHInN
ADHESIVE
SANDPAPER
Fig. 3
PAPER PUNCH
See Figure4.
A paper punch template has been suppliedwith the sand- er. It should be used for sflgning and punchingholesin the sandpaper for alignmentwith the holes in the cushion.
Punching the holes propertyis a necessarystep )n order tor the dustlessfeature of the sender to function property.
•Instattsandpaperon the sander.
•Align sander cushionto paper punch as shown by the iconon the paper punch template.
•Push down on sander.
PAPERPUNCH
Fig. 4
DUSTLESS SANDING
See Figure 5 - 6.
The dust bag providesa dust collectionsystem for the sander.Sanding dust is drawn up through the holes in the sandpaper end cushion and collects in the dust bag dur- ing sanding operation.For more effLcientoperation, empty dust bag when half full.
TO INSTALL DUST BAG:
•Unplug the sander.
•Aligngrooves on dust bag with notches on sander dust exhaust.
•Slide dust bag onto dust exhaust.
•Turn clockwiseuntil bag looksinto place.
TO REMOVE DUST BAG FOR EMPTYING:
•Unplug the sander.
•Turn dust bag counterclockwiseuntil it stops turning.
•Slide dust bag off sander dust exhaust.
•Shake to empty.
10
