ASSEMBLY INSTRUCTIONS
ATTACH INTERMEDIATE TUBE AND CON- CENTRATOR NOZZLE
Connect the intermediate tube (H) and air nozzle (I). Push the tubes together and turn them clockwise so that they lock together. (Fig. 7)
B DH 
I
45mm
56mm
Fig. 7
ADJUST BACK PACK HARNESS AND CONTROL HANDLE
1.Place blower on your back by slipping arms through the shoulder straps as if you were putting on a jacket (Figure 8).
2.Once adjustments have been made, to the straps for user comfort, remove the blower from your back and place on level ground in an upright position.
3.Adjust backpack harness and control handle.
Fig. 8
STARTING/STOPPING INSTRUCTIONS
STARTING A COLD ENGINE (Above 55˚F)
Fill fuel tank with proper gas and oil mixture. See FUEL AND LUBRICATION. Set unit upright on ground so that it rests on the back pack frame.
1.Pump primer bulb10 X by pressing up on the bulb(D). (Figure 10)
2.Your unit is designed with a 3 position choke: FULL CHOKE “ 
”, PARTIAL CHOKE “
”, and RUN “
”. Move choke lever to FULL CHOKE “
” position. (Figure 9)
3.Set throttle lock (C): While holding trigger (B) at wide open position, press down and hold throttle lock (C). Release throttle trigger (B), then release throttle lock
(C).Throttle trigger (B) will now remain in the wide open position. Make sure ignition switch is in the ON
(I)position. (Fig. 11)
1 
2
3
D
Fig. 10
C
A
B
Fig. 11
Fig. 9
10
