MOUNT DUST COLLECTOR ASSEMBLY TO WALL Refer to Figure 4.
To mount dust collector assembly:
•Lift dust collector assembly and position slots in wall brackets over installed anchored screws. Slide dust collec-
tor assembly down so that anchored screws rest in narrow portion of slots.
NOTE: Mounting dust collector will be easier and safer if done by two people.
•Tighten four screws using offset or short Phillips head screwdriver.
Anchored Screw
Figure 4 - Mounting Dust Collector Assembly
ATTACH COLLAR
Refer to Figure 5.
Collar needs to be attached to lower
•Pull filter down from dust collector housing.
•Make sure that filter is straight and there are no folds or creases.
•Bend and insert lower
•Pull down on collar to make sure that
|
|
| _Housing |
|
| Channel |
|
|
| _0_ | ._r__ (Inner) |
| |
|
|
|
|
| ||
|
|
| _/ | _// | Upper | Housing |
|
|
|
| Loop |
| |
|
| / |
|
| ||
Upper | _ | y) |
|
| ||
|
| _Upper |
| Collar | ||
|
| /" | ,Channel | (Inner) | ||
| Lower |
|
|
| ||
|
|
|
| _[_//Collar |
| |
|
|
| .... | \Lower | Collar | |
Figure | 5 - | Attach Collar | Channel | (Outer) | ||
ATTACH | COLLECTOR | BAG |
|
|
| |
Refer to | Figure 6. |
|
|
|
| |
Collector bag needs to be attached to collar using collector bag clamp. To attach collector bag:
•Remove collector bag clamp from collar.
•Slide collector bag over collar. Position bag approximately 2W' above lower edge of collar.
NOTE: The bottom of collector bag should rest flat on the floor, so that the floor supports the weight of wood dust and chips.
•Position bag clamp in lower channel of collar over bag.
•Position the spring connector into one of the slots on the latch and lock the clamp handle.
•Make sure collector bag is secure.
NOTE: The top of collector bag should NOT block the filter. If collector bag does block filter, fold excess bag over bag clamp.
Collector Bag
Figure 6 - Attaching Collector Bag
4
