z_

4rLWARNING: You MUST make sure

the tubes are secure before using the unit.

_WARNING:

Do not use the unit

without the tubes or collection bag prop- erly attached to avoid flying debris and/ or impeller contact which can cause se- rious injury. Always wear eye protection to prevent rocks or debris from being

blown or ricocheting into the eyes and face which can result in blindness or se-

rious injury.

STOPPING YOUR UNIT

Slide the ON/OFF switch to the OFF position.

STARTING YOUR UNIT

Your unit has two run positions, LOW and HIGH. Slide the switch to one of

these positions to turn on the unit.

OPERATING POSITION

Eye Protection

Eye Protection

BlowerVacuum

USING YOUR UNIT AS A BLOWER

WARNING: Inspect the area be- fore using the unit. Remove all debris and hard objects such as rocks, glass, wire, etc., that can ricochet, be thrown, or otherwise cause injury or damage during operation.

Use your unit as a blower for:

Sweeping debris or grass clippings from driveways, sidewalks, patios, etc.

Blowing grass clippings, straw, or leaves into piles, or removing debris from corners, around joints, or be- tween bricks.

Direct air flow by directing the blower tube down or to one side. Always work away from solid objects such as walks, large stones, vehicles, and fences. Clean corners by starting in corners and

moving outward. This will help prevent an accumulation of debris which could

fly into your face.

Be careful when working near plants. The force of the air could damage

tender plants.

USING YOUR UNIT AS A VACUUM

_'WARNING: Do not vacuum

stones, gravel, metal, broken glass, etc., to avoid severe damage to the im- peller. To avoid the possibility of elec- trical shock, do not attempt to vacuum water or other liquids.

Use your unit as a vacuum to pick up dry material such as leaves, grass, small twigs, and bits of paper.

For best results during vacuum use, operate your unit at high speed.

Move slowly back and forth over the material as you vacuum. Avoid forc- ing the unit into a pile of debris as this can clog the unit.

Keep the vacuum tube about an inch above the ground for best results.

_WARNING:

If the unit becomes

clogged, stop the unit and unplug the extension cord. Wait until the impeller has completely stopped turning, then remove the vacuum tubes. Carefully reach into the vacuum opening and clear out the clogged debris.

CUSTOMER

RESPONSIBILITIES

 

 

 

 

 

'_ WARNING:

 

Disconnect

power source

before

performing maintenance.

CARE

& MAINTENANCE

TASK

WHEN

TO PERFORM

Check

for

loose

fasteners

and parts

Before

each

use

Check

for damaged

or worn

parts

Before

each

use

Inspect

and

clean

unit and

labels

After

each

use

Remove and

empty

collection

bag

After

each

use

Clean

collection

bag

 

 

Yearly

 

 

 

 

 

 

 

 

 

 

9

 

 

 

 

 

Page 9
Image 9
Craftsman 358.74824 instruction manual Stopping Your Unit, Responsibilities, Maintenance Task